This listing is for the STL files to print your own SF Cyber Assassin Chassis parts **DIGITAL DOWNLOAD**
Please note the battery contacts shown in the photo are not included with purchase and are for reference on the type of contacts needed for installation.
Included in the download are the following:
Positive Battery Contact Holder - Glue the battery contact into the holders cut out. This one is press fit and holds in place well, though a dab of e6000 on the back will secure it even better.
Negative Battery Contact Holder - Glue the negative battery contact into the holders cut out and then glue the "legs" of the holder to the inner chassis just behind the speaker. I recommend using e6000 and allowing a full 24 hours cure time for the best results.
Verso, GHv3 and Proffieboard press fit holders. These holders are press fit/slide in units that fit in the small cut out inside the hilt. Lite sanding may be required for the best fit in the factory holder. Glue is optional but recommended if using the hilt for contact sports.